***updated 4/20/12*** its done scroll to the bottom of post for updated pictures!!!
As some of you know iv posted a couple times on a project build im working on im going to start posting pics in this thread over the next 2 weeks as i finish it
the case arrives tomorrow, when it comes in ill post a few pre-paint pictures and some post paint/mods but here is a small teaser
here is a 5 port baybus by lamptron the before and after shots of the cables
Before
after 4/5
again this is just a tease for the full build ill update with more tomorrow
here are some pics of the case panels, the case put together before paint, this was done to make sure nothing was missing or bent/damaged.
panels
base/front/back
top down view of case its massive
front panel
left side panel showing horizontal motherboard
front panel with baybus and 1 of 2 fan controllers the top slot will also house the dvd drive
Edit #3
case fans white with red sleeving
close up on the power/reset and hdd activity LED
*edit #4*
pictures of base coat before clear coat and wet sanding
this is 1 coat of paint doing a 2nd coat then clear coat then wet sanding should be finished tomorrow and start putting everything together friday/sat
*edit #5*
pictures of finished paint and partial assembly with most of the fans and panels put on
*edit #6*
well here it is the final pics
build components
case - mountain mod u2-ufo with custom paint
cpu - i7-2600k 4.8ghz
mobo - asus maximuz iv extreme z
ram - 8 gigs gskill -upgrading soon
gpu - xfx 7970 x2
psu - seasonic 1250 80+gold
cpu cooler
water block - apogee rev 2
radiator - black ice 360
pump - laning d5
res - ek spin dual bay
fittings - standard compression fittings for now switching to some 45 degree and monsoon fittings soon
11x spectre white 120m fans
2x kaze master pro 6 channel fan controller
1x lamptron hummer 5bay bus controller for lights
*edit #1* listed main components
*edit #2* added pics of case before paint
*edit #3* added pic of fans and case power/reset switches + hdd/activity LED
*edit #4* added pic of base coat
*edit #5* added pic of finished paint and partial assembly
*edit #6* final pics!! =)