Basically, I'm trying to create a new UI based around Pitbull4. I have a general set up, as seen here, but I'm falling short when it comes to configuring buffs. Debuffs on enemies are cool, but I need to disable them in the party frame for party members.
Also, I'm trying to figure out how to remove the friendly debuffs under my unit frame and remove them from the party frames, but still be enabled on my target frame.
Does anyone have any suggestions with this? Is it even doable in Pitbull4?
Last edited by mmocba105e19de; 2012-09-24 at 01:04 AM.
Is that something you can actually configure in Pitbull? I've been popping around the Modules and cannot seem to get one to stick and one to go; they're either both around or both gone. Hrm.
It's been ages since I last looked at the PB4 config, but it was something like this:
- There's a "Layouts" option page and a "Units" option page
- You first create a layout on the "Layouts" page"
- Then you select the layout to use for the unit on the "Units" page
Again, I'm not sure how exactly the menus were called.
Recent Blue Posts
Season of Discovery Hotfixes - 23 April
Season of Discovery Hotfixes - April 23
Dragonflight Season 4 Content Update Notes
MMO-Champion
Recent Forum Posts
Reply With Quote
