Was best picture I could take.
The two drive bay clamps were a cheap plastic that broke as soon as they were twisted to lock in place so currently not using them, they just sit there for now.
Anyone know some good quality red clamps? (I prefer the screws then the twist/lock method)
I tried shoving the wiring behind the drive bay, but it was going to warp the back side panel no matter how much I spaced them out, so I just bunched them up with some ties and placed the bundle in the bottom on the case.
At the time when I was installing the graphics card I didn't realize how low I had set it and would have bumped it up a slot or two, but the small shields that you take out on the back are punch outs and I haven't found a way to put them back in, so instead of punching out another shield I just left it on the lower slot and took a look at the temperatures to make sure if the gpu was becoming too hot under load. (Reaches 70c so not worth making the case ugly.)
Click to enlarge