So I set up my water cooling loop on Sunday, and after installing the WC parts in my case, I bled the loop for a few hours, and when I was done, the pump (D5) ended up being dead silent.
Since then I've installed my components, and had it run for a few days and there is now air in my loop again. The pump is a fair bit louder (still quiet) and at one point I spotted a big pocket of air in a tube when my pc was turned off.
I have one pump installed on the default side, which means I'm using the reservoir chamber on the right (bigger on top than the bottom). I can't get the chamber entirely free of air, because even when i fill it to the top of the fillport, there is still a little pocket of air inside.
I'm not sure which way i should rotate my case to get the air out of the loop, because one way is probably going to put air from the reservoir back into the loop. I know that the hole for water in is in the top left of the chamber, does anyone know where the out it?
My radiator is at the top of my case, the reservoir is just slightly higher than the cpu block.