So I have a Zalman Z11 Case, and a MSI Z77A-G45 Motherboard.
The motherboard was provided with a little block connector with labels as follows:
HD_LED+
HD_LED-
RST_SW-
RST_SW+
RSVD_DNU
Other side
PWR_SW-
PWR_SW+
FP PWR/SLP
FP PWR/SLP
Now from case I have HDD LED twin (So I'm guessing that goes on HD_LED + & -), RESET SW (So again on RST_SW + & -), POWER SW (So yet again on PWR_SW + & -)
Now left from the motherboard I have a POWER LED + and a -, do these go on the FP PWR/SLPs?
Also does it matter which colour is positive/negative? Reason I ask is the cable colours vary, with power sw being one black + one green, reset SW being black and red, and HDD LED being red and white.
And finally what goes on the RSVD_DNU?
Also it came with a 2nd small block with SPK + & -, BUZ + & -, is this needed to be used?
Edit: Also am I right to assume the first block once cables are attached, clip into JFP1 on the mobo?