Action bar paging

[Deleted]

Hi all

rerolled a druid yesterday and Im getting a little nervous about these actionbars swapping around all the time when I change form.
Is there any way I can set the action paging to just switch over all action bars instead of just action bar 1? (the main bar)

Im using ElvUI and this is the code I find within the configuration of actionbar 1:

[bonusbar:1,nostealth] 7; [bonusbar:1,stealth] 8; [bonusbar:2] 8; [bonusbar:3] 9; [bonusbar:4] 10;

I guess I need to put a similar code in the other action bars as well but I can't figure it out

thanks in advance.

[Ealyssa]

No, it's not possible. Only bar 1 can switch.

But you can make macros that cast spell depending on your druid form.

[Glurp]

If you use Bartender you can set any action bar to change when you shapeshift in the State Configuration menu. Note though that there is only a certain number of action bar pages so there might not be enough to do what you want.

[Alltat]

If you use Bartender you can set any action bar to change when you shapeshift in the State Configuration menu. Note though that there is only a certain number of action bar pages so there might not be enough to do what you want.

I think you get a total of twelve bars, allowing you to have three that page depending on form (using one each for caster, bear, cat and stealth). Since you probably don't need more than one of the bars to distinguish between normal kitty and sneaky kitty, you can do it using only ten bars.

[Deleted]

Is it possible then to page action bar 1 to, for example, actionbar 12 without copying the locations of the keybinds?

[Alltat]

Not in Bartender that I'm aware of. Or at least not with paging. You could however have two different action bars in the same place which are conditionally shown/hidden to behave like paged action bars. One only shows in cat form, one only shows in bear form, etc. You're still limited by the maximum allowed number of action bars, though.