At work, so I can't test right now, but can you put multiple castsequences in the same macro?
Something like:
Code:
#showtooltip Berserk
/cast Incarnation: King of the Jungle
/castsequence reset=2 ,Berserk
/castsequence reset=2 ,Tiger's Fury
Only relevent if you want a 1-bind macro to handle all your cds, you press once to activate the incarnation GCD, then press again to fire off the instants without losing time to incarnations gcd - I kinda prefer having a bind for each on my naga side buttons though.
Code:
/cast Incarnation: King of the Jungle
/castsequence reset=2 ,Berserk,Tiger's Fury
Worst case you could make it a three-button-push to activate the TF (like this)
- - - Updated - - -
Snapshotting question -
I have been updating my weakauras that monitor dot strength (so they track SR/TF/BT buffs) to also take advantage of predicted buffs in the future, so I now have a predicted strength shown if I were to clip at pandemic end / dot end, as well as showing what my current value is.
For TF/incarnation it is a straight forward question of if the cd will be up by those points.
For BT I check if I have Predatory Swiftness and will probably have BT up (estimated by assuming I gain 1 cp per 2sec, and assume BT will be up for the 2 gcd's after that).
The sim would generally refresh if it gets a better snapshot value as soon as it enters pandemic range, but wouldn't it be a gain to wait if you know your power is about to increase? The differences can be pretty extreme, from the base case that the sim would pandemic clip at (SR+TF at ~1.6x snapshot) up to 2x (rip) / 4.1x (rake).
Using the same aura's I can also see snapshot drops as they are coming - wouldn't it generally be a gain to take an amplified dot before the snapshot buff ends, even if it is pre-pandemic?
I can generally figure out enough of the simc apl to determine what it would do, but not enough to write it and sim either of these scenarios.